Open Photoshop and set
Width: 31 cm
Height: 3 cm
Resol;ution: 100
2. First we have to build the top line which is in cm and the bottom line which are in inches so each line at the top must have a thickness of 0.5mm and a height of 10.7 and 5 mm, respectively. depending on their position - extreme, central or intermediate, then I equidistanted them using a 1 cm rectangular control, and then I cloned 6 such units, following that the new 6cm object will be cloned 5 times, always paying attention to the areas overlap and alignment. The same method can be applied to the Inch area, but using a 1 inch wide rectangle and not forgetting the color of the ruler I will put the hex below
Comments